Kärcher K 3.495 Bedienungsanleitung Seite 14

Description of the Appliance
Illustrations on Page 2
1 Connection for water supply with filter
2 Coupling element for water connection
3 Appliance switch "0/OFF"/ „I/ON"
4 High pressure hose
5 High-pressure hose drum
6 Storage for trigger gun
7 Transport handle
8 Hand crank for hose drum
9 Storage for accessories
10 Mains cable with mains plug
11 Detergent Tank
12 Detergent suction hose with detergent
filter and cover
13 Wheels
14 Trigger gun
15 Lock trigger gun
16 Key to detach the high pressure hose
from the trigger gun
17 Spray lance with Dirtblaster
18 Spray lance with pressure regulation
(Vario Power)
Special accessories
Special accessories expand the possibili-
ties of using your appliance. Please contact
your KÄRCHER dealer for further informa-
tion.
Before Startup
Illustration
Mount loose parts delivered with appliance
prior to start-up.
Illustration
 Push the high pressure hose into the
trigger gun until it locks audibly.
Note: Make sure the connection nipple
is aligned correctly.
 Check the secure connection by pulling
on the high pressure hose.
14
Warning
According to the applicable regula-
tions, the appliance must never be
used on the drinking water supply
without a system separator. Use a
suitable system separator manufactured by
KÄRCHER; or, as an alternative, a system
separator as per EN 12729 Type BA. Water
flowing through a system separator is con-
sidered non-drinkable.
Caution
Always connect the system separator to
the water supply, never directly to the appli-
ance!
Note: Impurities in the water can damage
the high-pressure pump and accessories.
For protection, the use of the KÄRCHER
water filter (optional accessory, order no.
4.730-059) is recommended.
Water supply from mains
Observe regulations of water supplier.
For connection values, see type plate/tech-
nical data.
 Use a fibre-reinforced water hose (not
included) with a standard coupling.
(Minimum diameter 1/2 inch (13 mm),
minimum length 7.5 m).
Illustration
 Screw the coupling element to the wa-
ter connection on the appliance.
 Push the water supply hose onto the
coupling unit, then connect it to the wa-
ter supply.
– 6
EN
Water supply