Werbung
Verfügbare Sprachen
Verfügbare Sprachen
6.
Wiring Diagram
7.
Operation
Put the switch in the "ON"-position. Place the device on the floor and verify whether it moves smoothly. Clap
your hands repeatedly to make the KSR2 execute the following steps: stop move forward to the left stop
move forward to the right stop move forward in a straight line. Adjust "VR" with a screwdriver to
change the microphone's sensitivity. Turn the screwdriver to the right for increased sensitivity and vice versa.
8.
Troubleshooting
1. Make sure all components on the PCB are in the right position. Pay particular attention to the polarity of the
microphone, the transistors, capacitors and the IC's.
2. Check the wiring.
3. The noise from the gearbox may prevent the microphone from receiving the signal. Grease face gear
36T/14T (white) and the metal shaft (n°3) to reduce the noise.
4. Do not grease metal shaft (n°4) and gears 36T/0T (white) and 36T/14T (red).
Use this device with original accessories only. Velleman nv cannot be held responsible in the event
of damage or injury resulting from (incorrect) use of this device. For more info concerning this
product and the latest version of this manual, please visit our website www.velleman.eu. The
information in this manual is subject to change without prior notice.
© COPYRIGHT NOTICE
The copyright to this manual is owned by Velleman nv. All worldwide rights reserved. No part of this
manual may be copied, reproduced, translated or reduced to any electronic medium or otherwise without the
prior written consent of the copyright holder.
V. 02 – 31/01/2018
KSR2
Fig. 11
9
©Velleman nv
Werbung
