Kärcher G200FA Bedienungsanleitung Seite 18

Check oil level
 Switch off engine switch.
 Park the machine on an even surface.
Illustration
 Remove the oil filling screw with oil dip-
stick and wipe dipstick clean.
 Insert the oil fill screw with the oil dip-
stick all the way into the oil fill opening
(do not screw in) and remove it again.
Read the value of the oil level.
 In case of low oil level:
Fill in motor oil (SAE 10 W30) up to the
lower edge of the oil fill opening.
(For maximum filling quantity refer to
"Technical data").
 Screw in oil filling screw.
Oil change
Perform oil change when the engine is
warm.
Illustration
 Remove the oil filling screw with oil dip-
stick and wipe dipstick clean.
 Unscrew the oil drain screw and collect
oil.
 Fix in the oil drain screw and tighten it.
 Park the machine on an even surface.
 Fill in motor oil (SAE 10 W30) up to the
lower edge of the oil fill opening.
(For maximum filling quantity refer to
"Technical data").
 Screw in oil filling screw.
Check the air filter
Illustration
 Remove the air filter housing.
 Clean or replace soiled filter elements.
 Replace damaged filter elements.
 Reassemble the air filter.
18
Cleaning the sediment cup
Illustration
 Close fuel cock.
 Unscrew the sediment cup.
 Remove O-ring.
 Clean the sediment cup and the O-ring
using non-flammable solvent and allow
them to dry.
 Insert the O-ring into the fuel cock.
 Screw in the sediment cup and tighten
it.
 Open fuel cock
 Check sediment cup for leaks.
 Replace the O-ring in case of leaks.
Check spark plug
Illustration
 Remove spark-plug connector.
 Clean the spark plug and the surround-
ings.
 Unscrew spark plug.
 Replace spark plugs with worn elec-
trodes or broken insulator.
Illustration
 Check the distance between the elec-
trodes of the spark plug.
ATTENTION
A loose spark plug can overheat and dam-
age the engine.
A spark plug that is excessively tightened
damages the thread in the cylinder head.
Observe the information on tightening the
spark plug.
 Carefully screw in the spark plug by
hand. Do not cant the thread.
 Turn the spark plug up to the stop using
the spark plug wrench and tighten it as
follows:
Tighten used spark plugs with 1/8...1/4
rotation.
Tighten new spark plug with 1/2 rota-
tion.
 Push on spark-plug connector.
– 5
EN