Cameo S2 IP Bedienungsanleitung Seite 17

Protocol Artnet and sACN
Select by turning the encoder, confirm by pressing, change value or status by turning, confirm
by pressing. Back with ESC.
Universe Setting the Universe
Universe Group Setting the Universe Group
DMX Address Setting the DMX start address
DMX Mode Selecting the DMX mode
Setting the IP address:
1. Set block with middle encoder
2. Set block with right encoder
IP Address
Press middle encoder (Next Range)
3. Set block with middle encoder
4. Set block with right encoder
IP Address Press the left encoder to save (Enter)
Setting the subnet mask:
1. Set block with middle encoder
2. Set block with right encoder
Subnet Mask
Press middle encoder (Next Range)
3. Set block with middle encoder
4. Set block with right encoder
Press left encoder to save (Enter)
Forwarding the control signal via XLR Out
Forwarding the control signal via W-DMX
Forwarding the control signal via XLR Out
Signal Routing
and W-DMX
Control via XLR with Artnet or sACN signal
interruption
STANDALONE OPERATING MODE CCT (Correlated Colour Temperature)
Starting from the main display, press the left-hand rotary-push encoder to access the menu for
selecting the operating mode. Turn the left encoder (SELECT) to select CCT (note the selection
arrow on the left) and confirm by pressing the left encoder (ENTER). You can now set the bright-
ness (DIM), colour temperature (CCT) and hue (Tint) by turning the three rotary-push encoders
(see illustration).
Turn encoder =
Set brightness (DIM)
Press encoder =
Selection of the operating mode
Turn encoder =
Setting the colour tone (Tint)
Press encoder =
Open main menu (Menu)
Turn encoder =
Set colour temperature (CCT)
000–255
000–127
001–512
1CH Dim ... 16CH Pixel
xxx.xxx.xxx.xxx.xxx
xxx.xxx.xxx.xxx.xxx
xxx.xxx.xxx.xxx.xxx
xxx.xxx.xxx.xxx.xxx
Send to XLR
Send to WDMX
Send to Both
Backup by XLR
17