Control Panel; Power On/Off Button (Power); Mode Change Button (Mode); Timer Button (Timer) - Noaton AC 5109 Gebrauchsanweisung

Lokales klimagerät

Vorschau ausblenden Andere Handbücher für AC 5109:

Inhaltsverzeichnis

Verfügbare Sprachen

Control panel

Once connected to the mains power supply, the air conditioner will enter standby mode, the display will flash

for a time and emit an audio signal. Press the on/off button (POWER) and the unit will switch to the initial

"Smart" mode. To protect the compressor, when the appliance is switched back on it will not start for a period

of three minutes.

By pressing the on/off button once again you will switch off the appliance; the fan will continue to function for

an additional 10 seconds or so after the machine has been switched off.

Press the MODE button to change available modes - COOL/SMART/FAN.

If the air conditioner is in standby mode, using the timer button and the "

" and "

" buttons you can set an

interval between 1 and 24 hours after which the appliance will switch itself on. The appliance display will show

the remaining time until it starts up in hours [Note: always rounded up to the nearest whole hour; so, if e.g.

there is 1 h and 15 min until the start, the display will show 02].

In this mode it is also possible to set the required setting after the appliance has started, either by using the

buttons on the display or with the remote control.

If the air conditioner is switched on an running, you can use the timer button to set an interval between 1 and

24 hours after which the appliance will switch itself off.

By selecting 0 hours the timer function will switch itself off.

Inhaltsverzeichnis