Herunterladen Inhalt Inhalt Diese Seite drucken

Ⅵ: Cleaning And Maintenance - Nordmende MT-VF71 A Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

All manuals and user guides at all-guides.com
Ⅴ .DEFROSTING
For the most efficient operation and minimum energy consumption, defrost the freezer
when the frost on the evaporator is excessive 3 to 4 mm thick. To start defrosting, turn the
temperature control to 'OFF', unplug the freezer, remove the food and drawers. After the
frost or ice has melted, discard the melted water and dry up the interior of freezer. Then the
freezer can be restarted by a turning its thermostat to the desired setting.
CAUTION: Never use any sharp of metallic instruments (e.g. knives) to remove frost/ice
from the evaporator as this will damage the evaporator. A punctured evaporator will cause
serious problems.
Ⅵ: CLEANING AND MAINTENANCE
1. To clean the freezer, disconnect power supply and remove foods, drawers etc. Use a
solution mixed with 2 spoons of baking soda per litre of warm water to clean the interior.
Then wipe it clean with fresh water.
Never use acids, chemical thinner, gasoline, benzene or the like for cleaning any part of
the freezer.
Never use oiling water and benzene to clean plastic parts because they may deform or
damage the plastic parts.
2. Too much foods or a too large container in the freezer will affect cold air circulation, so
some free space must be left. It is recommended that about 70% storage volume is loaded.
Do not store volatile and or explosive materials such as ethers, gasoline, liquefied
petroleum gas, adhesives etc. in the freezer. Otherwise there will be a danger of explosion
caused by electric sparks.
Ⅶ. SAFETY INSTRUCTIONS
Before plugging your freezer in check that the electric supply in your house must comply
with the rating (voltage, frequency) of the freezer, the rating plate is usually on the back of
the freezer. The freezer should always be plugged in its own individual electrical outlet to
prevent overload, which could cause a possible fire hazard from overheating wires. Do not
splash water on the freezer as this will cause electrical leakage or failure. If the power cord
becomes damaged, ask on electrician to replace it immediately. The freezer must be
properly earthed.
Our corporation is not responsible for any accident caused by improper earthing or
improper operation.
Any repairs and work on the appliance should only be carried out by the customer service
department, as unauthorized work could prove highly dangerous for the user.
Do not store explosives or sprays using combustible propellants such as butane, propane,
- 10 -
Create PDF
files without this message by purchasing novaPDF printer (http://www.novapdf.com)

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis