Quick Start; Other Functions - Velleman HQ Power CAMCOLVC26 Bedienungsanleitung

6. Operation

6.1 Quick Start

1. Loosen the screw and open the lid at the bottom of the camera. Insert
an SD card (not incl.) in the SD card slot [7].
2. Slightly press the second lid to open the battery compartment [10].
Insert four 1.5 V AA-type batteries (not incl.) according to the
indicated polarity. You can also power the camera through an active
USB port of a computer. To do so, insert the USB plug of the included
USB cable into the USB port [8] and connect to your computer.
3. Switch on the camera with the on-off button [g]. Press OK [f] to enter
the test mode.
4. Press MENU [a] to enter the setting menu. Navigate through the menu
with the navigation buttons [b, c, d, e], modify with up or down [c,
e], and press OK [f] to confirm.
5. Hold OK [f] pressed for five seconds to enable the camera to work
automatically.
6. Select picture or video recording with the photo/video selector [h],
and select your IR LEDs with the LED selector [i]. The GPRS
function [j] is not available on this model.
7. Once your picture or video recording mode selected, press OK [f] to
take a picture or to start/stop the video recording.
8. Open the battery compartment [12] of the support. Insert four 1.5 V
AA-type batteries (not incl.) according to the indicated polarity. Fix the
support where desired using the included strap. Click the camera onto
the support and secure with the locks [11].
Remarks

6.2 Other Functions

Video/Photo Playback
1. Switch on the camera with the on-off button [g] and press OK [f].
2. Press [e] to enter the playback mode.
3. Press or
your selection.
4. Press [e] again to go back.
V. 01 – 17/11/2014
CAMCOLVC26
We recommend disconnecting the USB cable from the
camera when using battery power.
We also recommend not using rechargeable batteries.
Instead, use fresh alkaline batteries in both the camera
and the support simultaneously.
[b, d] to select your photo/video; press OK [f] to play
7 ©Velleman nv