JBM 60044 Bedienungsanleitung Seite 7

REF. 60044
set again in the full reverse mode.
LED working light
The LED light can be used in poor lighting conditions to
illuminate the work area.
The LED light will turn on as soon as you press the trigger.
Turning off the tool
To switch off the machine, release the trigger
CAUTION! When removing sockets from the tool,
avoid contact with skin and use proper protective
gloves. Sockets may be very hot after prolonged
use.
MAINTENANCE
Repairs must be performed by a qualified expert using only
identical replacement parts.
This will ensure that the safety of the tool is maintained.
Disconnect the battery pack before changing accessories.
Recharge the battery at least once a year to maintain its
charging capacity.
CLEANING
Unplug the battery from the tool and the charger from the
wall outlet before cleaning.
Clean the tool with a clean cloth or clean with compressed
air at low pressure.
Do not use any cleaner or detergent they can damage the
plastic parts of the tool.
Ensure that no water enters the tool.
We recommend cleaning the tool directly after each use.
DISPOSAL
This device uses electronic components so
they should not be deposited with household
garbage.
Dispose of the tool in a recycling center.
· 7 ·