Parts List - JBM 60044 Bedienungsanleitung

PARTS LIST

1 Square drive
2 Direction selector and trigger lock
3 Handle
4 Speed selector
5 Trigger
6 LED light
OPERATION
Turning on the tool
Set the trigger lock to avoid an accidental turning on.
Insert the battery pack on the base of the tool.
Note: You can check the battery charging status by pressing
the button on the battery.
Press the direction selector to chose the direction of the
square drive.
Tighten
To activate the tool, press the trigger.
Speed control
The motor has an electronic clutch with three different forward
speed settings: low, medium and high.
Press this button to select the speed:
A green light will turn on to indicate the selected gear.
Also, the speed depends on the amount of pressure you apply
to the trigger. Light pressure on the trigger results in a low
rotational speed. Further pressure on the switch results in an
increase in speed
To loosen
The electronic clutch has two different reverse modes: Full
reverse and non-continuous.
The full reverse mode is automatically activated when the
direction switch is put into the reverse position.
No LEDs on the gear indicator should be illuminated.
In the non-continuous mode, when you press the trigger, the
anvil will do a small counterclockwise rotation and then it will
completely stop.
To select the non-continuous mode, press the MODE button.
A green light will turn on:
Loosen
To deactivate the non-continuous mode, push the MODE
button again. The green LED will turn off and the tool will be
· 6 ·
Low Medium
Full reverse Reverse non-continuous
REF. 60044
High