Hama N300 Bedienungsanleitung Seite 7

• Then call up the address http://ap.setup in your
Web browser. (Alternatively, you can also call up the
repeater's IP address 192.168.10.1)
• Select a language and enter the password. Then click
'Login' to start the configuration. The default password
is admin.
• Select 'Wizard'.
• Then select 'Repeater'.
• The repeater lists all available networks. Select the
desired network and enter the password for your
network. Then click 'Connect'. You can change the
router's SSID, if desired. However, we recommend that
you use the same SSID as your wireless network uses.
• When you have clicked 'Connect', the repeater will
restart. You must now connect your computer to the
new network.
• Alternatively, you can also configure the repeater using
a network cable. To do so, connect your computer
and the repeater with a network cable. You can then
continue with the above configuration, from 'Then call
up the address http://ap.setup....'.
6.2.3 Troubleshooting
If the repeater's status LED (4) does not light up as
described, the connection could not be established.
Please consult the following information in order to fix
the problem.
• Check the location in which you installed the
repeater; we recommend plugging in the repeater for
configuration in the immediate vicinity of your WLAN
router.
• Check whether the WPS function is activated in the
firmware on your WLAN router or whether your WLAN
router supports this procedure at all.
• Check whether your WLAN network is using a hidden
SSID; we recommend not hiding the SSID for the initial
setup.
• Check whether your WLAN network is using the 2.4
GHz band. The Hama repeater only supports the 2.4
GHz band.
7. Warranty Disclaimer
Hama GmbH & Co KG assumes no liability and provides
no warranty for damage resulting from improper
installation/mounting, improper use of the product or
from failure to observe the operating instructions and/
or safety notes.
8. Consumption information according to directive
(EU)
No. 801/2013 amending the directive (EC)
No. 1275/2008
Status
Manual standby
(Ready state (Standby)
on devices without
information or status
indicator (manual)*)
Networked standby
mode***
*Press the Power button
***Ethernet cable connected
Please note that the actual power consumption can be
dependent on multiple factors. These include the personal
settings, the operating mode, the ambient temperature
and the firmware version of the product used. The values
set out above represent maximum values.
The actual reference values can be found at:
www.hama.com -> 00053306 -> Downloads ->
Consumption information
9. Declaration of Conformity
ereby, Hama GmbH & Co KG declares that
H
the radio equipment type [00053306] is in
compliance with Directive 2014/53/EU. The
full text of the EU declaration of conformity is
available at the following internet address:
www.hama.com -> 00053306 -> Downloads.
Frequency band(s)
Maximum radio-
frequency power transmitted
Power
Duration of
consumption
trigger time
(Watt)
– 0.1 W
≤ 20 min ≤ 1.8 W
2412 MHz - 2472 MHz
2.4 GHz / 100mW (EIRP)
5