Warranty Card - neno Kitty Bedienungsanleitung

included in the kit.
04. LIGHT CONTROL WITHOUT REMOTE CONTROL:
1. To switch on the light, press the cat's tail.
2. To change the brightness of the light or the colour press and hold the tail.
The light will start to change brightness and when it reaches its lowest
intensity it will change colour to cold or warm white.
3. Another press of the tail will put the light into RGB mode. In this mode, the
colours will automatically start to transition from one to another. You can
also gently tap the kitty which will cause the RGB colours to change sequen-
tially and the meowing sound.
4. The next press of the tail will cause the light to switch off.
05. CONTROL OF THE LIGHT BY REMOTE CONTROL:
1. Press the on/off button to turn the light on or off
2. Press the „- „ button to dim the lamp
3. Press the „+ „ button to brighten the lamp
4. Press one of the 8 buttons to select the colour of the light or the button with
automatic RGB colour-switching mode.
5. Press one of the buttons „15min" „30min" or „60min" to have the lamp
automatically switch off after the specified time. When one of the buttons is
pressed, the lamp will dim and brighten to indicate that the time has been
successfully set. To deactivate this mode, press the on/off button.
06. SPECIFICATION
Material: silicone/ABS/PC
Battery: 1200mAh allowing the light to be used for up to 100h at minimum light
intensity and up to 8h at maximum light intensity.
Input: DC5V 0.5A
Power: 0.2-1.5W
Light colour temperature: warm light 3000K, white light 6500K + colour RGB
Dimensions: 155x102x81 mm
Weight: 175g
Charging time: approx. 4.5 h.
Maximum radiated RF power in the frequency range: - 45 dBm
Frequency range: 433 MHz

07. WARRANTY CARD

The product comes with a 24-month warranty. Warranty terms and conditions can
be found at: https://neno.pl/gwarancja
Details, contact and address of the service can be found at:
https://neno.pl/kontakt
8