Lindy 38396-7 Benutzerhandbuch Seite 6

User Manual
Decoder 38397
1. POWER LED: This will flash red when the system is booting, will illuminate red when booting
successfully.
2. LINK LED: This will illuminate green when there is an input signal, will flash green when it gets no
signal.
3. USB 1.1: Connect to a mouse or keyboard.
4. RESET Button: Press and hold this button when the unit is powered-on until both POWER and LINK
LEDs will flash simultaneously, then release the button to restore the default settings.
5. DC 12V: Connect the 12VDC 1A PSU to an AC wall outlet and securely connector to the unit.
6. LAN (PoE): Connect to 1G Network Switch using a single RJ-45 Cat.6 or above cable to create a
distributed system. The unit can be powered via PoE if the connected Switch has this feature.
7. IR IN: Connect the supplied IR Receiver cable for IR signal reception. Ensure the remote being used
is within the direct line-of-sight of the IR Extender.
8. IR OUT: Connect the supplied IR Transmitter Cable for IR signal transmission. Place the IR Transmitter
in direct line-of-sight of the equipment to be controlled.
9. USB 2.0: Connect to USB 2.0 devices.
10. RS-232: Connect to a PC, Serial Controller or Serial device via a phoenix block 3-way connection for
the pass-through transmission of RS-232 commands.
11. MIC IN: Microphone interface (only for point-to-point connection).
12. AUDIO OUT: Analog Audio output interface which can output the same audio signal from the HDMI
OUT port if audio format is LPCM.
13. HDMI OUT: Connect to a HDMI Display.
Operation
Web GUI
This Extender supports playing Secondary Stream on computer through a software such as VLC media
player, simultaneously it can be managed via the built-in Web GUI to configure the Secondary Stream.
Please follow the below steps to enter the Web GUI:
1. Connect the Encoder with a PC, an HDMI source device and the power supply as shown below:
English