Inhaltsverzeichnis
Werbung
Alon
User manual
Thank you for purchasing the Lightpro Alon.
This document contains the required information for
correct, efficient and safe use of the product. Consult the
user manual of your transformer for more information
about the installation and connection of your lighting
plan or visit our website www.lightpro.nl
Read the information in this manual carefully before
using the product. Keep this manual near the product for
consultation in the future.
PRODUCT DESCRIPTION
The Lightpro Alon is a standing LED lamp for outdoor
use. The fixture can be placed in the ground with the
spike provided. This product may only be used as
outdoor lighting in combination with the Lightpro 12-volt
system. Any alterations made to the product may have
consequences for the safety, guarantee and correct
functioning of the product and/or other parts of the
system.
SPECIFICATIONS
Product
Article number
Light source
Power (max.)
Luminous flux (max)
Light colour
Average lifetime
Dimensions (W x H x D)
Protection class
Ambient temperature
Cable length
Dimmable
Light source
On/off
PACKAGING CONTENT
[Figure A]
1. Alon fixture
2. Ground spike
3. Screws and plugs
4. Hex key
5. Lightpro F-connector
Lightpro Alon
221P
LED 3,3W AC/DC 12V
3,3W
40 - 220 lm
3.000K
25.000 Hours
64 x 700 x 160 mm
IP44
-20°C to 50°C
1m
Yes
Not replaceable
10.000
Check if all parts are present in the packaging.
For questions about parts, service, and any complaints or
other remarks, you can always contact us.
E-mail: info@lightpro.nl
INSTALLATION
OPTION 1: INSTALLATION IN THE GROUND.
[Figure B]
Secure the spike [2] to the base [1] with the supplied
screws [3] using the hex key provided [4].
OPTION 2: INSTALLATION ON SOLID GROUND
[Figure B]
1. Fix the plug [2] to the substrate in reverse using the
screws [3] provided.
NB: Pre-drill holes if necessary and use the plugs
provided [3].
2. Place the fixture [1] on the spike [2].
SETTING THE DIMMER
The Oberon DL comes with a dimmer that can be set to
6 different pre-programmed levels.
[Figure C]
1. Remove the glass from the fixture by sliding it upwards.
2. Adjust the desired brightness using the push-button
below the light source.
3. Slide the glass back onto the luminaire.
NB: Thanks to the memory function, the dimmer will
retain the set level when the light is switched off.
retain the set level.
Werbung
Inhaltsverzeichnis
