Inhaltsverzeichnis
Werbung
Barite 40
User manual
Thank you for purchasing the Lightpro Barite 40.
This document contains the required information for
correct, efficient and safe use of the product. Consult the
user manual of your transformer for more information
about the installation and connection of your lighting
plan or visit our website www.lightpro.nl
Read the information in this manual carefully before
using the product. Keep this manual near the product for
consultation in the future.
PRODUCT DESCRIPTION
The Lightpro Barite 40 is a standing LED lamp for
outdoor use. The fixture can be mounted on a solid
surface or placed in the ground with the supplied spikes.
This product may only be used as outdoor lighting in
combination with the Lightpro 12-volt system. Any
alterations made to the product may have consequences
for the safety, guarantee and correct functioning of the
product and/or other parts of the system.
SPECIFICATIONS
Product
Article number
Light source
Power (max)
Luminous flux (max)
Light colour
Average lifetime
Dimensions (H x Ø)
Protection class
Ambient temperature
Cable length
Dimmable
Light source
On/off
PACKAGING CONTENT
1. Fixture Barite 40
2. Ground spike
3. Screw
4. Screw
5. Plug
6. Lightpro connector
7. Hex key
9. Mounting Bax
Barite 40
112P
MR16 LED GU5.3 3W AC/DC 12V
3W
230 lm
3.000K
25.000
405 x 65 mm
IP44
-20 °C to 50 °C
1m
No
Replaceable
10.000
Check if all parts are present in the packaging. For
questions about parts, service, and any complaints or
other remarks, you can always contact us.
E-mail: info@lightpro.nl.
INSTALLATION
[Figure B]
Remove the screws [8] from the fixture [1] using the
included hex key [7].
[Figure C]
Haal de voet [9] uit het armatuur [1]Remove the base [9]
from the fixture [1].
OPTION 1: Placement in the ground
[Figure D]
Fasten the spikes [2] to the base [9] with the included
screws [3].
[Figure E]
Place the base [9] in the fixture [1].
[Figure F]
Put the screws [8] back in the fixture using the hex key [7].
Place the fixture in the ground.
OPTION 2: Placement on a fixed underground
[Figure G]
Mount the base [9] on the underground using the
included screws [4].
If necessary, drill holes in advance and use the
included plugs [5]
[Figure H]
Place the fixture [1] on the base [9].
[Figure I]
Put the screws [8] back in the fixture using the hex key [7].
REPLACEABLE LIGHTSOURCE
Proceed as follows in order to install or change the light
source:
1 Turn the power off.
2 Let the light source cool down for at least 5 minutes.
3 Replace the light source, bearing the following points
in mind:
• Only replace the light source by an identical model with
the same specifications.
• When (re)assembling, ensure that the parts are dry and
clean.
4 Turn the power back on.
Proceed as follows if the lamps do not light after you
have followed the above instructions:
1 Turn the power off.
2 Check whether all plugs have been connected properly.
3 Check the light source(s) and replace them if necessary.
4 Check the transformer and the fuse (if applicable, and
have them circuit-tested if necessary).
5 Check whether cables have been damaged.
6 Turn the power back on.
Werbung
Inhaltsverzeichnis
