Cleaning & Maintenance - Daewoo DKCC350 Gebrauchsanweisung

Indicator Lights:
Fully Charged
Safety Switch ON
Safety Switch OFF
Device working
Battery low power
Troubleshooting:
Incident
Device not working
after installing the
machine
Charging
Bad smell from the
motor at first time
use
Blade stuck
4). Cleaning & Maintenance
1. Clean the chopper body, blades, and cup after use with water
2. Rinse the device with water and wipe out with a soft, dry cloth. When cleaning, put some
detergent in the water and clean with warm water.
3. Do not touch the blades with the hands directly to avoid injury.
4. Do not use abrasive or corrosive cleaning agents for cleaning
5. Do not put any parts of the device in high temperature sterilizer.
6. Dry all parts of the device after cleaning and store the chopper in a secure place,
out of reach of children.
7. Charge the device at least 1 time for every 3 months if not using the machine for a long time.
Status
Charging
Indicator status
Red and Blue lights
ON
Red light ON
Red light not turning
ON
Indicator light
Red light ON
Blue light ON
Blue light flashes 5 times
Red and Blue light flashes 2 times
Blue light turns ON
Red light turns on for 10 seconds
Possible reason of
failure
Jar not properly
installed
Motor is damaged or
stuck
Please check
connection of
charging port and
power cable
It is normal for new
motor
The blade is stuck
with food
5
EN
Solution
Install the jar in
accurate position and
align with the
magnetic sensors
Send to maintenance
store for inspection
Go back to your
dealer to get this
checked out.
Switch off the
chopper, take out the
chopper main body
and remove the food.
Continue the process
with less food inside