Live/Preset Mode; Live Mode; Preset Mode; Saving A Preset - Rocktile MRC-90-LOOP Bedienungsanleitung

LIVE/PRESET mode

The MRC-90-LOOP has two different operating modes.
By briefly pressing the two buttons 2+3, you can switch between the two operating
modes.

LIVE Mode

In LIVE mode, the MRC-90-LOOP acts like a pedalboard with 7 effects that can be
used separately and combined as desired.

PRESET mode

In PRESET mode, different effect combinations can be stored in four memory
locations.
Note: PRESET mode only stores the on/off state of the four effect modules
(DELAY/REVERB + CHORUS/PHASER + DISTORTION + OVERDRIVE). Their
individual effect parameters as well as the settings of LOOPER, CAB and BOOST
are not stored.
With the help of the PRESET mode, fast and comfortable switching times can be
realized, e.g. during performances or for recording sessions, even during individual
songs.

Saving a Preset

Switch to LIVE mode.
Activate one or more effect modules that you want to use.
Press and hold one of the foot switches 1-4 until the respective LED starts flashing.
The preset is now stored. Four memory locations (A-D) are available.

Recalling a Preset

Switch to PRESET mode.
Tap the respective footswitch (1-4) whose previously stored PRESET you want to
recall.

TUNER

The MRC-90-LOOP has a built-in pedal TUNER.
Press both footswitches 2+3 simultaneously for about 3 seconds to activate TUNER.
The output signal is muted and the display switches to TUNER mode.
Now play a single empty string. The tuning tone is now shown in the display. At the
top of the display, several LEDs indicate the tuning status.
Blue LED in the middle at the top of the display -> tuning tone reached
Red LEDs on the left side -> tuning pitch too low
Red LEDs on the right side -> tuning pitch too high
10