Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Information
Important: Please charge the battery fully before using it for the first time, otherwise the light cannot be used due to
•
the circuit protection. The protection will be automatically cancelled after charging.
•
Do not use the light in high temperature and high humidity, this product is not suitable for outdoor use.
The light source and battery of the product are not replaceable. If the brightness of the product is very low after a long
•
time at full power, or the service life becomes shorter under normal use, the entire lamp must be replaced.
Operation
•
Press the button for the first time to enter ON mode. In ON mode, the sensor function does not work and the light
remains on.
Press the key for the second time to enter the sensing mode. The sensor function is activated after the light flashes
•
three times.
•
Press the key for the third time to turn the light off.
•
When the light is on, the brightness can be adjusted by keeping the key pressed.
Capture mode
The detection mode turns the light on when moving through the detection area in the dark. If
•
the environment is well lit, the light will not turn on in detection mode.
If you leave the detection area, the light automatically turns off after about 25 seconds.
•
•
The light stays on if one remains in the detection area.
the installation position, such as too low, too high or the probe has been blocked, affects the
•
detection area. It is recommended to install the probe towards the passing side for better effect.
The detection mode can be blocked by glass.
•
Mounting
1. Please clean the installation place and keep it dry.
2. Put the iron sheet on the back of the light to find the position of the built-in magnet.
3. Glue it to the target position.
Caution: The adhesive surface must face outwards. Do not glue the iron sheet to the light!
Charging procedure
Do not use a charger with an output voltage higher than 5 V to charge the light.
•
•
To ensure the safety and efficiency of charging, please use the cell phone charging adapter with safety certificate to
charge the light.
Do not use the light while charging (the sensor mode may not work normally, which will affect the light when
•
charging).
Disposal instructions
According to the European WEEE Directive, electrical and electronic equipment must not be disposed of with household
waste. Their components must be recycled or disposed of separately, because toxic and hazardous components can cause
lasting damage to health and the environment if disposed of improperly. As a consumer, you are obliged under the Electrical
and Electronic Equipment Act (ElektroG) to return electrical and electronic equipment free of charge at the end of its service
life to the manufacturer, the point of sale or to public collection points set up for this purpose. Details are regulated by the
respective state law. The symbol on the product, the operating instructions and/or the packaging indicates these regulations.
By separating, recycling and disposing of old equipment in this way, you are making an important contribution to protecting
our environment.
Packaging can be disposed of free of charge at the appropriate collection points - paper in the paper garbage can, plastics in
the yellow bag and glass in the used glass container.
Hergestellt von ETT Distribution GmbH, Schmalbachstraße 16, 38112 Braunschweig
ett-online.de | Tel. +49 531 58 11 00 | service@ett-online.de
Nachdruck oder Vervielfältigung nur mit ausdrücklicher Genehmigung.
Stand 12/2022
Artikelnummer: 1453014
Werbung
