Installation - Bluetooth Adapter - Enduro BC101 Bedienungsanleitung

In the event of malfunctions, pull on the handbrake immediately and
turn off the main isolation power switch.
To maintain signal strength, always make sure that, during
manoeuvring, the distance between the remote control and the
caravan does not exceed 5 meter.
Due to the nature of a remote signal, it can get corrupted by
external terrain or objects. So there may be small areas around the
caravan where the quality of reception reduces, hence the
manoeuvring system may stop momentarily.
Do not make any modifications on the system (mechanical or
electronically). This can be very dangerous! No warranty claim will
be accepted and we cannot guarantee the function of the system if
any modifications are made. We will not be liable for any damage
whatsoever caused as a result of incorrect installation, operation or
modification.
INSTALLATION – BLUETOOTH ADAPTER
FOR PROFESSIONAL INSTALLATION ONLY! These instructions
are for general guidance. Installation procedures may vary
depending on caravan type.
Working under a vehicle without appropriate support is
extremely dangerous!
Place the caravan on a hard, level surface. The use of a lifting ramp or an
assembly pit is ideal for access and personal safety.
Unpack all the components and check for the presence of all parts (see
package contents list).
The Bluetooth adapter (1) should be mounted on the outside of your
caravan. Note: when installing the Bluetooth adapter (receiver) inside the
caravan, the Bluetooth signal will be too weak for a good communication
and therefore the system will not work well. The Bluetooth adapter is
designed for mounting on the outside of the caravan floor via the two
supplied screws (2) (Fig. 1). Position it at such a place that the Bluetooth
adapter (receiver) has a good and open space for a good communication
all around the caravan.
Route the cable along the underside of the caravan floor, if possible inside
the convoluted trunking (this will protect the electrical cables against
sharp edges and dirt) and through the drilled hole.
®
EN BC101 17
DURO
Ref: BC101-UM-TKI-0415-Rev.A.