Beacon Lighting LUCCI AIR LONDO Bedienungsanleitung Seite 50

LONDO - USING YOUR CEILING FAN
REMOTE CONTROL
1. Test the remote by pressing and hold any button. A blue LED will be lit up at the top of the remote
to indicate that there is power to the remote and it is ready for use to control the fan.
2. Follow the guide below to operate the fan and learn the functions.
The remote has memory function. If the fan or light is turned off by the isolating switch, it will memorise and
recover the last status when turned on next.
REPAIRING THE FAN RECEIVER & REMOTE PAIRING
NOTE: The pairing of the remote and receiver has been done at the factory.
When the ceiling fan is installed, pairing the fan receiver and remote is NOT required.
Should the remote and receiver lose control after installation or during use, the pairing of the remote and the
receiver must be repaired. Below are the operating symptoms and method to repair the pairing of the DC
ceiling fan remote and receiver.
Issues:
•
Loss of control - Fan is only running at high speed after installation
•
Loss of control - No reverse function after installation
•
Loss of control - Remote cannot communicate with the receiver
49 | Page
1) Direction of the fan (reverse switch)
2) Speed of the fan
3) ON/OFF the fan
4) Timing control of the fan
5) ON/OFF the light
6) Natural wind
(Press the button to set the fan running at changing speed automatically. If the
fan is working at speed 1, 2, 3, then press this button to let the fan run at a
lower changing speed. If the fan is working at speed 4,5,6, then press this
button to let the fan run at a higher changing speed.
7) Anti-theft function(the light ON 5~20 minutes every 2 hours)
8) 1.5V AAA battery X 2 pcs (Not included)