Changing The Battery - Hama FANCY STAND Bedienungsanleitung

• The Bluetooth
last used with.
• Slide the On/Off switch (2) from the OFF position to ON. The pilot light (1) starts
to ash blue.
• After 3-5 seconds, the Bluetooth
device.
• You can now use the Bluetooth
Note - connection impaired
After a successful initial pairing, the connection is established automatically.
If the Bluetooth
• In your device's Bluetooth
If not, repeat the steps described in 6.1. Bluetooth pairing.
• Check whether obstacles are impairing the range. If so, move the devices closer
together.
• The performance may also be impaired if the battery is low. Change the battery
if necessary.
• Only one Bluetooth
to another device, disconnect this pairing and try again.

6.3. Changing the battery

The battery was designed for a use of up to 2,000 triggers, however this lifespan
depends on the conditions of use. If the Bluetooth
when the trigger button (2) is pressed, does not connect to the Bluetooth
then change the battery as follows: See (B).
7. Care and maintenance
Only clean this product using a lint-free, slightly damp cloth and do not use any harsh
cleaners. Ensure that no water is able to enter the product.
8. Warranty disclaimer
Hama GmbH & Co KG assumes no liability and provides no warranty for damage
resulting from improper installation/ mounting, improper use of the product or from
failure to observe the operating instructions and / or safety notes.
6
remote trigger remains connected to the Bluetooth
®
connection is not established automatically, check the following:
®
settings, check that hama BRS4 is connected.
®
device can be connected at a time. If it is still actively paired
®
remote trigger automatically pairs with the
®
remote trigger.
®
®
remote trigger does not respond
device it was
®
device, etc.,
®