The First Time; Before You Start; Mounting The Wall Charging Station - Swirl Quinyo Bedienungsanleitung

4 The first time

Before you start

Pleasure comes before work:
ƒ Remove the packaging material, the
strips of tape and the protective films
from the appliance.
ƒ If possible, retain the original packaging
for transport purposes.
ƒ Please dispose of packaging residues
in an environmentally friendly
manner. ............................... page 29
ƒ Check that all parts are externally
undamaged and that the battery is
inserted in the suction unit.
ƒ Push the release buttons together and
pull the EasyBag holder out of the
®
housing.
Check that the EasyBag
seated on the socket.
Insert the EasyBag holder into the hous-
®
ing until the edge closes.
ƒ To test the function, press the on/off
switch and let the appliance run briefy.
Mounting the wall charging
station
You need: a drill and bit, a screwdriver, a
tape measure – and a little bit of manual
skill.
ƒ Look for a suitable place: near to a
socket and on a wall that you can drill
into.
Warning! Do not damage any power
cables, gas or water pipes when drilling.
Risk of personal injuries and property
damage!
ƒ Mark the holes for drilling as follows.
ƒ Note the type of wall:
is completely
®
ƒ Fasten the wall charging station on the
23
B
A Min. 105.0 cm
Max. 120.0 cm
B 7.1 cm
C 8.0 cm
Note the minimum height for A so that
the appliance can be suspended freely
together with the suction tube and rotary
foor nozzle.
ū With a brick or concrete wall, you
drill holes for the plugs.
ū With a wooden wall, you drill holes
directly for the screws.
ū With a plasterboard wall, you may
need special plugs.
wall.
Caution! Do not tighten the screws too
much, as the housing can otherwise be
damaged.
The first time
41.34 in
47.24 in
2.79 in
3.16 in