earth+kin e+k MULE Bedienungsanleitung Seite 7

Installing the All-Terrain Wheels
Slide the wheel axles into the axle receivers
on both sides of the Frame Assembly and
press DOWN to secure until you hear a click
(Figure 6). Then pull up on each wheel to
ensure a proper connection.
NOTE: It may be necessary to press the
quick release pin on the axle receiver
(Figure 7) to install the wheel correctly.
To Remove the Wheels, press the quick release pin
on the axle receiver and pull UP to slide the Wheel
off the Frame.
Installing the Pull Handle
Requires: 2 pins
Slide the Pull Handle into the two tubes on
the front of the Frame Assembly (Figure 8)
and secure with pins.
Installing the Roll Bars
Requires: 4 pins
Slide the Roll Bar into the two tubes on each
side of the Frame Assembly so the holes in
the tubes are aligned with the holes on the
Roll Bars, and secure with pins (Figure 9).
NOTE: The logo on the Roll Bars should be
facing the outside of the Wagon.
Figure 6
Figure 8
Figure 9
EN
DE
ES
FR
Figure 7
7