Working Modes - FLINQ FQC8262 Bedienungsanleitung

EN Manual

Working Modes

- Press the on / off button, lamp will automatically turn on to Sensor Mode.
- Keep pressing the on / off button for 3 seconds and shining one time, lamp turns to constant
lighting mode.
Sensor mode
120° 120°
1 Battery above 30%
Automatically lights up at night and turns
to full brightness when motion is detected
in the range of ≤8mtrs. After that, it will dim
to lower brightness after 20 seconds of no
motion.
Constant lighting mode
1 Constant lighting mode
Press the button for 3 seconds and the light will shine one time. Now the lamp turns to Keep
Lighting Mode, both motion and light sensors are disabled. Permanently keep lighting until the
battery capacity reduces to zero and the switching back to Sensor Mode.
120° 120°
2 Battery below 30%
Automatically lights up at night and turns
to full brightness when motion is detected in
the range of ≤8mtrs. The lamp then turns off
after 20 seconds of no motion.
Applications
You can easily install it for garden, courtyard, parking lot, square, villa, garage,
pathway, entrance etc.
Notices
1. This is a solar powered lamp, please install it in a location where can get enough sunshine.
2. Please note the lighting time depends on sunshine duration & weather & work mode.
3. The lamp will light up automatically at dusk in Sensor Mode.
4. Built-in intelligent IC is with over-charge, over-discharge and over-voltage protection.
5. The lamp is equipped with an internal battery pack, which is replaceable. If any need, please
contact seller for correct new battery pack.
6. If the battery is taken out and put back in or replaced with new ones, please toward the solar
panel to sunshine or a strong light to activate the lamp.
7. Non-professionals please do not disassemble the lamp.
8. Please do not dispose the battery with household garbage to avoid explosion.
FlinQ Solar LED Floodlight 10W