Removing The Drive Shaft; Disassembly Instructions For The Angled Screwdriver Head; Removing The Gear Cap Using The Rotatable Handle - KLS Martin group ANGULUS Gebrauchsanweisung

6.5

Removing the Drive Shaft

Pull the drive shaft out of the shank.
•
Assembly is carried out in reverse order.
6.6

Disassembly Instructions for the Angled Screwdriver Head

6.6.1

Removing the gear cap using the rotatable handle

Unscrew the cap using the short, square tip of the rotatable handle.
•
To remove the gear cap, you can also use a screwdriver with a Center Drive 2.0 mm bit
REF (Item no. 25-542-17-07).
40
Instructions for Use
Angled Screwdriver ANGULUS
V. 2.0