5.4 Device Unpairing - iLine microsystems Microinr link Bedienungsanleitung

• When the microINR Link Meter is
paired the "Process Correct" symbol
appears on the Meter's screen. The
microINR Link Meter can only be paired
with one compatible device at a time.
Unpair the microINR Link Meter before
pairing with another device (see
section 5.4). If a new pairing process is
attemped while the microINR Link
Meter is already paired, the "Process
Incorrect" symbol will be displayed on
the Meter's screen for 4 seconds.
Once the pairing process starts, the
microINR Link Meter is accesible for
60 seconds to pair with a compatible
device. If the microINR Link Meter does
not connect with another device, the
"Process Incorrect" symbol will appear.
The "Unpaired Device" symbol will
appear on the lower right side of the
screen.
The Pairing process can be cancelled at any time by pressing
the left button or inserting a Chip.

5.4 DEVICE UNPAIRING

• Enter the Bluetooth Menu to unpair the
microINR Link Meter. Ensure that the
Meter is turned off and no cable is
connected to the USB port. Turn the
Meter on by pressing the left and right
button at the same time for 4 seconds.
• Press the right button to reach the
unpairing option and then press the
left button.
• The unpairing process starts
automatically. After a few seconds the
"Process Correct" symbol is displayed
on the Meter's screen for 4 seconds.
The "Unpaired Device" symbol appears
on the lower right side of the screen.
To skip the Bluetooth Menu, press the right button until you
get to the "Exit" option (see section 5.2). You can also insert a
microINR Chip or after 20 seconds of inactivity the Meter will
skip the Menu automatically.
Once the microINR Link Meter is unpaired, it is advisable
unpairing also the electronic device that was previously
connected to the Meter.
16