Kesser K-Wave 3600 Bedienungsanleitung Seite 10

4. Connecting the battery:
a. Connect the anode (+) red cable to the anode (+) of the battery terminal.
b. Connect the cathode (-) black cable to the cathode (-) of the battery terminal.
c. Before use, make sure that the battery is fully charged to ensure the working voltage. An 80AH depth
cycle gel battery is recommended.
5. Side control:
Rotate the handle as shown in the illustration to control the direction of your boat:
6. Read the LED voltage indicator to avoid battery damage
7. Replacement of the propeller:
Use appropriate tools to loosen the mounting screw of the propeller:
Remove the propeller:
Leave the rod stuck on the shaft when removing the propeller:
In reverse order, you can reseed the propeller.
10
There are 10 LEDs on the display, the 7 upper ones are
green, and the 3 lower ones are red. If all 7 green
lights are off, this means that the input voltage is lower
than 9.5V, you need to turn off the motor and
disconnect the battery from the motor, otherwise this
could cause permanent damage to the battery.