ChiQ LOW-E CBE46DMF4EC Bedienungsanleitung Seite 7

This cooler must be grounded. This cooler is equipped with a cord having a grounding wire with a
grounding plug. The plug must be inserted into an outlet that is properly installed and grounded.
Consult a qualified electrician or service person if the grounding instructions are not completely
understood, or if doubt exists as to whether the cooler is properly grounded.
WARNINGS:
• Improper use of the grounding plug can result in a risk of electric shock.
• Do not, under any circumstances, cut or remove the third ground prong
from the supplied power cord.
Connecting to power
• Plug the appliance into a dedicated, properly installed grounded wall outlet.This appliance should
be operated on a separate electrical circuit from other operating appliances.
CAUTION:
This unit is not designed to be installed in an RV or used with an inverter.
• Plug in and run your cooler for three to four hours before making any
temperature adjustments and before adding beverages. This allows your
cooler to reach a stable temperature.
Notes:
• Check your local power source. This cooler requires a
power supply.
• Use a receptacle that accepts the grounding prong. The power cord is
equipped with a 3-prong (grounding) plug which plugs into a standard
3-prong (grounding) wall outlet to minimize the possibility of electric shock hazard
from this cooler.
• To prolong the service life of the compressor, wait for at least five minutes before
restarting the cooler after a power failure.
• Do not use an extension cord with this cooler. If the power cord is too short,have a qualified
electrician install an outlet near the cooler. Use of an extension cord can negatively affect the
cooler's performance
Using your beverage cooler
Temperature seting
The temperature of the appliance can be adjusted by turning the thermostat dial.
The thermostat can be set between 1 and 7.
• 1 is the warmest setting.
• 7 is the coldest setting.
• Set the dial to OFF to turn off the cooling function.
 Under the normal operating condition (in spring and autumn), it is recommended to set the
temperature at 4 .
 In summer when the ambient temperature is high, it is recommended to set temperature at
3-4 , so as to guarantee the Beverage Cooler
temperatures and reduce the refrigerator continuous running time; and in winter when the
ambient temperature is low, it is recommended to set temperature at 5-6 to avoid frequent
start/stop of the Beverage Cooler.
Notes:The temperatures may vary with respect to setting's ones due to compressor cycles and
outside conditions.
.
220V-240V, 50 Hz