Continuous Measurement; Area Measurement; Volume Measurement - Levenhuk Ermenrich Reel GA50 Bedienungsanleitung

Continuous measurement

Press (7) to enter continuous measurement mode. Press (2) to turn the laser on. Aim the laser beam at the target and press (2) again. The
device will keep taking measurements one after another. MAX, MIN, and the last measured values (Fig. B) will be displayed on the screen.
Press (9) to stop the continuous measurement, and press (9) again to return to single measurement mode.

Area measurement

Press (4) to enter area measurement mode. Aim the laser beam at the target and press (2) to measure 2 sides of the target. The area will
be calculated automatically (Fig. C).

Volume measurement

Press (4) to enter volume measurement mode. Aim the laser at the target and press (2) to measure the length, width, and height of the
three-dimensional target. The volume will be calculated automatically (Fig. D).
Calculations with 2 additional measurements (Pythagorean theorem)
Press (4) to enter the calculations with 2 additional measurements (Pythagorean theorem). Aim the laser at the target and press (2) to
measure the lines А and В (Fig. E). Line C will be calculated automatically.
Figure B
Figure C
Figure D
Figure E
5