Levenhuk Ermenrich Reel GA50 Bedienungsanleitung Seite 4

Ermenrich Reel GA50 Laser Meter
EN
Getting started
Open the battery compartment cover and insert 2 AAA batteries according to the correct polarity. Close the cover.
Using
Press (2) to turn the device on. Press (2) to turn the laser on and aim the laser beam at the target. Press (2) again to measure the distance.
Press (6) and hold it for 3 seconds to turn the buzzer on/off.
Press (9) and hold it for 3 seconds to turn the device off.
Reference point
The default reference point is the bottom end of the device. Press (8) to change the measurement point from the bottom to the top of the
device (Fig. A).
Units of measurement
Press (6) to change the unit of measurement.
Units of measurement options
Distance
1
0.000m
2 0.00ft
3 0.0in
Display information
Single distance measurement mode
Area measurement mode
Volume measurement mode
Calculations with 2 additional measurements
(Pythagorean theorem)
Single distance measurement
When the device is turned on, it goes into single distance measurement mode automatically. Press (2) to turn the laser on. Aim the laser
beam at the target and press (2). The value will be displayed on the screen.
Figure A
Area
0.000m 2
0.00ft
2
0.0in
2
4
Volume
0.000m 3
0.00ft
3
0.0in
3
Calculations with 3 additional measurements
(Pythagorean theorem), method 1 – legs
summation
Calculations with 3 additional measurements
(Pythagorean theorem), method 2 – legs
subtraction
Battery status