Operating Condition - TANDBERG DLT4000 Bedienungsanleitung

Summary of Front Panel Indicators
Use the following tables to determine the drive's operating conditions:
LABEL COLOR
STATUS INDICATORS (right side)
Write Protected Orange
Tape in use Yellow
Use Cleaning Yellow
Cartridge
Operate Handle Green
All four right side
or all left side
indicators
LABEL COLOR
DENSITY INDICATORS (left side)
2.6 Yellow
6.0 Yellow
10.0/15.0 Yellow
20.0 Yellow
Compress Yellow
Density Override Yellow
All four right side
or all left side
indicators
STATE

OPERATING CONDITION

On Cartridge is write-protected
Off Cartridge is write-enabled
Blinking Cartridge is loaded and the tape is moving.
On Cartridge is loaded; ready for use.
On Drive head needs cleaning, or the tape is bad.
Remains on after Cleaning tape attempted to clean the drive head, but the tape
you unload the expired, so cleaning was not done.
cleaning cartridge
After cleaning, Problem data cartridge. Try another cartridge.
turns on again
when you reload
the data cartridge
Off Cleaning is complete, or cleaning is unnecessary.
On Okay to operate the cartridge/ insert release handle.
Off Do not operate the cartridge insert/release handle.
On Power-on Selftest is starting.
Blinking A Power-on Selftest error has occurred. Press the Unload
button or turn drive power off and then on again to clear the
error. If the error remains, call your service representative.
STATE OPERATING CONDITION
On Indicates the tape is recorded in 2.6 GB format.
Blinking Indicates the tape is recorded in another density. You have
selected this density for a write from BOT.
On Indicates the tape is recorded in 6.0 GB format.
Blinking Indicates the tape is recorded in another density. You have
selected this density for a write from BOT.
On (default) Indicates the tape is recorded in 10.0/15.0 GB format.
Blinking Indicates the tape is recorded in another density. You have
selected this density for a write from BOT.
On (default) Indicates the tape is recorded in 20.0 GB format.
Blinking Indicates the tape is recorded in another density. You have
selected this density for a write from BOT.
On Compression mode enabled. (Compression can be done in
10.0/20.0 GB density only.)
Off Compression mode disabled.
On You have selected a density from the front panel.
Off (default) Density to be selected by the host (automatic).
Blinking You are in density selection mode.
Blinking A Power-on Selftest error has occurred. Press the Unload
button or turn drive power off and then on again to clear the
error. If the error remains, call your service representative.