Herunterladen Inhalt Inhalt Diese Seite drucken

Safety Instructions - Vogue Y836 Bedienungsanleitung

Mandoline
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 9
EN

Safety Instructions

T
HE MANDOLIN IS A POTENTIALLY DANGEROUS APPLIANCE AND MUST ONLY
BE USED BY TRAINED PERSONNEL IN ACCORDANCE WITH THESE INSTRUCTIONS
Position on a flat, stable surface.
A service agent/qualified technician should carry out installation and any repairs if required. Do not
remove any components on this product.
Consult Local and National Standards to comply with the following:
• Health and Safety at Work Legislation
• BS EN Codes of Practice
Blade edges are sharp - DO NOT touch the blade edges.
DO NOT attempt to cut bones or items that are frozen. This can damage the blades.
Keep all packaging away from children. Dispose of the packaging in accordance to the regulations of
local authorities.
Introduction
Please take a few moments to carefully read through this manual. Correct maintenance and operation of
this appliance will provide the best possible performance from your VOGUE product.
Operation
Set-up
Unfold the front and rear legs [Fig. 1].
1.
Note: Always hold the blades by the plastic handles when handling.
2.
Slot the required Julienne blade into the appliance with the cutting edges facing UP the appliance
[Fig. 2].
Note: Ensure that the blade slots firmly into place, with the handle protruding from the
other side of the mandolin.
AND/OR
Insert the straight or serrated blade into the mandolin with the blade edge facing UP the appliance
3.
[Fig. 3]. Firmly push the blade into the appliance until the blade release [Fig.6] clicks into place.
Note: The serrated blade cannot be used at the same time as the Julienne blades.
Adjusting the Thickness
Loosen the two guide plate knobs, located on either side of the mandolin [Fig. 4].
1.
2.
Gently move the guide plate to the required position. Push down to lower, push up from below to
raise.
Note: The lower the plate the thicker the slice.
3.
Tighten the knobs when the guide plate is in position.
1

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis