P-Settings - IO HAWK Legacy 2.0 Handbuch

P-SET.
You can access the display settings by pressing and holding the "+" and "-"
keys on your display simultaneously. We do not recommend making any
changes to the settings. (Scooter must be turned on)
P01：Backlight brightness: level 1 is the darkest, level 3 is the brightest.
Default setting: 3
P02：Kilometer reading: unit, 0：KM；1：MILE；default setting: KM.
P03: Voltage level: 24V，36V，48V，52V，60V. Default: 52V
P04: Rest time: 0 corresponds to no rest time; other numbers correspond
to rest time. The range is 1-60 minutes. Default: 5
P05: Reserve
P06: Wheel diameter: The unit is inches. The accuracy is 0.1; default: 10.0
P07: Speedometer; the range is 0-255. This will affect the overall accuracy
of your speedometer. Default: 28
P08: Speed limit; the range is 0-100km/h. Default: 100
P09: Kickstart、no kickstart；0 means kickstart. 1 means no kickstart.
Default value: 0
P10: Reserve
P11: EABS switch selection. The range is 0-5.0 means closing.1 means
weakest. 5 means strongest.
P12: Starting dynamics: The range is 1-5. The softest value is 1.
P13: Reserve
P14: Reserve
P15: Undervoltage of the controller
This setting controls the voltage cutoff for your scooter. This feature helps
protect the overall life of your scooter's electrical system.
Note: For the Legacy 2.0, the lowest setting should not be less than 48V.
Ideally, it should be set at 52V. If you are unsure where your scooter should
be set, you can check on the controller.
P16: ODO zero setting (total kilometers): Press and hold + for 5 seconds,
ODO will be reset to zero.
P17: If it shows 0, it can't use cruise control, if it shows 1, it can use cruise
control. Default:0 (removed because not allowed in Germany).
P18: Bind and unbind NFC cards: long press "+" to bind, long press "-" to
unbind.
P19: Reserve
P20: The communication protocol is preset to 4 and cannot be changed.
41