Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
2 Setting up the Doorbird IP Video door station
2.
Select Expert Settings > SIP Settings and activate the "Enabled" switch first.
3.
Enter the IP address of your SIP server in the "SIP Proxy" field. Under "SIP User" and "SIP
Password", enter the access data that you have assigned for your DoorBird IP video door
station in your Fritzbox or the Tek-SIP software:
4.
Turn on the "DTMF" switch and enter a PIN number of your choice under "Relay 1 PIN",
which you can then use to control the door relay of your DoorBird IP Video door station
from YOUVI.
5.
Select "Save". If a "200" is now displayed at the end of the page under "Last error code",
the registration was successful. If not, check whether the user name and password in the
SIP server and Doorbird interface are actually identical. Pay attention to upper and lower
case. If a "0" is displayed as error code, save again.
6.
Now go to Favorites > SIP Numbers and select "Add".
7.
Under "Name", enter the panel name "Controlmini", for example. As SIP address, enter SIP
name of the panel or phone number and IP address of the SIP server as follows:
−
<SIP username>@<SIP server IP address>, for example for TekSIP: Controlmini@10.2.42.22
or for Fritzbox: **623@10.2.42.245:
26
Werbung
Inhaltsverzeichnis
