Connections And Controls; Initial Setup - Sharp SUMOBOX CP-LSBP1 Schnellstartanleitung

6
Box contents
• CP-LSBP1 battery pack
• Charger
• 2 pin (type C) plug adapter
• 3 pin (type G) plug adapter
• User documentation

Connections and Controls

(Refer to on page 2).
1. Battery Status LED: Press the button to see
the battery status.
2. USB Charging Port (5V 1000mA): Allows
mobile devices to be charged.
3. Connection to SumoBox
4. DC 18V Input: Allows charging of the battery
when not installed in the SumoBox.
Initial set up
Charge the supplied CP-LSBP1 battery pack with
the included charger. Ensure you use the correct
plug adapter for your region.
Charge the battery for a minimum of four hours.
EU
UK
NOTE: When charging with the included charger,
please keep the battery upright.
When charging with the included charger, the
battery level LED will blink at the current power
level. When the battery is fully charged, the LEDs
on the battery pack will turn off.
Alternatively, you can install the CP-LSBP1
battery pack into the SumoBox and connect to
the SumoBox to the mains power supply. Charge
the battery for a minimum of four hours. When
inserting into the SumoBox, ensure the battery
clip engages to secure it in place.
NOTE: When the SumoBox is connected to
the mains supply and the CP-LSBP1 battery is
installed, the battery will automatically recharge.
Once charged, to avoid power consumption,
ensure the switch on the SumoBox is set to the
"off" position and then unplug the SumoBox.
You can press the battery status button to see
the power level of the battery:
DC IN
10 % – 25 %
26 % – 50 %
51 % – 75 %
76 % – 100 %