HairMax LaserComb Ultima 9 Bedienungsanleitung Seite 12

ELECTROMAGNETIC IMMUNITY GUIDANCE
Guidance and manufacturer's declaration – electromagnetic immunity
The Ultima 12(KM908) and Ultima 9(KM907) are intended for use in the
electromagnetic environment specified below. The customer or the user of the
Ultima 12(KM908) and Ultima 9(KM907) should assure that it is used in such an
environment.
Immunity test
Conducted RF
IEC 61000-4-6
Radiated RF
IEC 61000-4-3
NOTE1 At 80 MHz and 800 MHz, the higher frequency range applies.
NOTE2 These guidelines may not apply in all situations. Electromagnetic propagation is affected by
absorption and reflection from structures, objects and people.
a
Field strengths from fixed transmitters, such as base stations for radio (cellular/cordless)
telephones and land mobile radios, amateur radio, AM and FM radio broadcast and TV
broadcast cannot be predicted theoretically with accuracy. To assess the electromagnetic
environment due to fixed RF transmitters, an electromagnetic site survey should be
considered. If the measured field strength in the location in which the Ultima 12(KM908) and
Ultima 9(KM907) are used exceeds the applicable RF compliance level above, the Ultima
12(KM908) and Ultima 9(KM907) should be observed to verify normal operation. If abnormal
performance is observed, additional measures may be necessary, such as re-orienting or relocating
the Ultima 12(KM908) and Ultima 9(KM907).
b
Over the frequency range 150 kHz to 80 MHz, field strengths should be less than 3 V/m.
11
IEC 60601
test level
3 Vrms
150 kHz to 80 MHz
3 V/m
80 MHz to 2.5 GHz
!
!
Compliance Electromagnetic environment-guidance
level
3 Vrms Portable and mobile RF communications
equipment should be used no closer to
any part of the Ultima 12(KM908) and
Ultima 9(KM907) including cables, than the
recommended separation distance calculated
from the equation applicable to the frequency
3 V/m of the transmitter.
Recommended separation distance:
d = 1,2 √P
d = 1,2 √P 80 MHz to 800 MHz
d = 2,3 √P 800 MHz to 2,5 GHz
Where P is the maximum output power rating
of the transmitter in watts (W) according to
the transmitter manufacturer and d is the
recommended separation distance in metres
(m).
Field strengths from fixed RF transmitters, as
determined by an electromagnetic site survey,
should be less than the compliance level in
each frequency range.
Interference may occur in the
vicinity of equipment marked
with the following symbol:
b
a