HairMax LaserComb Ultima 9 Bedienungsanleitung Seite 10

After drop/shock, that may cause changes in the performance, please
contact customer service.
Be careful, do not put the power cord around your neck, it may cause
strangulation.
Keep the device out of the reach of children/pets to avoid inhalation or
swallowing of small parts.
Do not use the device if it is damaged in any way. The continuous use of a
damaged unit may cause injury, improper results, or serious danger.
The device should be used only with the accessories recommended for use
by the manufacturer.
When not in use, store the device with the adapter in a dry room and protect
it against extreme moisture, heat, lint, dust and direct sunlight. Never place
any heavy objects on the storage case.
ELECTROMAGNETIC EMISSIONS GUIDANCE
Guidance and manufacturer's declaration – electromagnetic emissions
The Ultima 12(KM908) and Ultima 9(KM907) are intended for use in the
electromagnetic environment specified below. The customer or the user of the
Ultima 12(KM908) and Ultima 9(KM907) should assure that it is used in such an
environment.
Emission test
RF emissions CISPR 11
RF emissions CISPR 11
Harmonic emissions IEC 61000-3-2
Voltage fluctuations/flicker emissions
IEC 61000-3-3
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) the device
must accept any interference received, including interference that may cause undesired
operation.
9
Compliance
Group 1 The Ultima 12(KM908) and Ultima 9(KM907)
use RF energy only for its internal function.
Therefore, its RF emissions are very low and
are not likely to cause any interference in
nearby electronic equipment.
Class B The Ultima 12(KM908) and Ultima 9(KM907)
are suitable for use in all establishments,
Class A including domestic establishments and
those directly connected to the public low-
Compliance voltage power supply network that supplies
buildings used for domestic purposes.
Electromagnetic
environment-guidance