Care And Cleaning - KITCHEN GEAR 900101590101 Gebrauchsanweisung

FOR OMELETS
1. Place the egg boiler on a clean, dry surface.
2. Remove lid and other parts.
3. Fill the measuring beaker with cold water to the marking.
4. Pour cold water into base/heating plate.
5. Place the egg cooking rack on top of the base, the flat side should be facing upwards.
6. Lightly butter or spray vegetable oil on omelet tray.
7. Break up to 2 eggs into a separate bowl and mix, add extra liquid for best result e.g.,
water or milk. Pour the mix into the omelet tray.
8. Place the omelet tray on top of the egg rack.
9. Place the lid on top of the unit and turn the switch on to soft cooking mode.
Indicator light will be lit. Only start the appliance with the lid on.
10. When the omelet is finished the appliance will turn itself off and the buzzer will sound.
11. Turn the switch to off-mode, remove the lid and immediately, also remove
the omelet to prevent overcooking.
12. Use a kitchen utensil, e.g., spatula to remove the omelet from the tray.

CARE AND CLEANING

Always unplug the egg boiler from the electrical outlet and allow to cool down
before cleaning. Some residue water in the base is normal after use.
WARNING! Base is extremely hot after use.
• Allow unit to cool before handling or cleaning.
• Do not submerge base of unit in water or liquid.
• Wash all removable parts in hot soapy water. Thoroughly dry all parts and
place next to the unit or store them when not in use.
• Wipe the body housing with a damp cloth.
• Clean heating plate with a damp cloth.
• To remove any mineral remains; Use a paper towel moistened with one tablespoon
white vinegar.
• NOTE: If the base is not cleaned regularly, minerals naturally occurring in water will
build up and cause discoloration of eggshells. However, discoloration of the eggshells
does not affect the taste of the eggs.
• Use the cord wrap feature located underneath the unit to store extra cord.
Place the egg rack, omelet tray and poaching tray inside the egg boiler to store.
• Any other service should be performed by an authorized service representative.
8