Buffalo CH133 Bedienungsanleitung Seite 4

EN
Assembly
Remove all packaging materials from the appliance.
Position on a worktop and ensure the appliance is secured in
position.
Wash all parts before use (see section "Cleaning, Care &
Maintenance").
• Warning: Ensure the appliance is switched off and
disconnected from power supply before assembly/
disassembly.
• BUFFALO accept no responsibility for any injury
caused by incorrect assembly.
• Cutting blade is sharp! Handle with care!
Locking handle
Feed screw
Cutting blade
Barrel cap
Stuffer nozzle
1. Insert the mincing barrel into the motor housing mouth, with the
shaft facing upwards.
2. Rotate the handle clockwise to secure the mincing barrel.
3. Insert the feed screw into the mincing barrel.
4. Mount the cutting blade on to the end of the feed screw. Ensure the
sharp edge side faces forwards as shown.
5. Choose the desired cutting plate and match the groove on the edge
to the pin on the mincing barrel. Then slide the cutting plate on to
the feed screw.
6. Screw the barrel cap to the end of the mincing barrel until tight.
7. Insert the hopper tray.
8. If making sausages, install the stuffer nozzle onto the mincing barrel.
Note: Before this, ensure to unscrew the barrel cap first. After the
nozzle is mounted, re-attach the barrel cap and screw tight.
4
CH133-CH134_ML_A5_v2_20230329.indb 4 CH133-CH134_ML_A5_v2_20230329.indb 4
Feeding chute
Cutting plate
Food pusher
Hopper tray
Mincing barrel
Switch
"RESET" button
2023/3/29 15:27 2023/3/29 15:27