VANTRUE VP01 Bedienungsanleitung Seite 13

3.5 Test your installation according to
below steps.
1. Insert the TYPE-C end into the dash cam,
start the ignition, waiting for the dash cam
to start.
2.
After the dash cam starts, turn off the car
and unplug the key to check if the dash cam
is turned off or goes into parking mode.
After confirming that the dash cam is off or
3.
in the parking mode, restart the car to check
whether the dash cam can start recording
normally. If all the above steps pass the test,
it indicates that the normal circuit and ACC
signal test passed.
3.6 Route the power cable.
① Carefully route the power cable around
the windscreen and tuck it under the trim.
- 8 -
N E N N E N E E