Westfalia 979659 Originalanleitung Seite 8

OPERATION
Charging the Hair Clipper and Beard Trimmer
Connect the power mains adaptor (7) to a wall socket and to the charging
socket on the clipper. The LED indicator light (3) will light up red to indicate the
unit is charging. Charging will take approximately 1.5 hours and the LED
indicator light will turn blue once the charge is complete. There will be more
than 1 hour of running time.
The charger must not be used in damp rooms.
The hair clipper and beard trimmer can be operated during the charging
process.
Before Clipping or Trimming
Inspect the clipper to make sure that it is free from hair and dirt. Before
cutting. The Hair must be dry before cutting. Always comb the hair so it is
tangle free and dry.
Attaching a Comb
Unlock the mounting slide with the slide (4). Fully retract the mounting slide for
the comb (8) with the adjustment wheel (2). Place the comb over the front of
the clipper and push down the mounting latch (5) until it engages with an
audible click.
Removing a Comb
Fully retract the mounting slide for the comb (8) with the adjustment wheel (2)
and lock it in position with the slider (4) on the underside of the clipper. Then
push the mounting latch forward and away from the machine with your finger
until it disengages.
Adjusting the trim Length
The comb assembly can be extended and retracted by turning the Adjustment
wheel (2). Make sure you lock the comb assembly in place with the slider (4) on
the underside of the clipper.
Operation
Slide the ON/OFF Switch (1) forward to turn on the clipper. Slide the switch
back to turn off the clipper.
After each Use
 • Make sure the clipper is switched off.
 • Gently brush the remaining hairs away from the comb and trimmer blade.
8