Functions And Usage - Xblitz RF200 Bedienungsanleitung

05. FUNCTIONS AND USAGE

To turn the radio on, press the PWR button on the radio or 1 on the remote control.
A. VOLUME
1. When the audio mode with default volume control is turned on, turn the knob
right to turn the volume up or left to turn it down.
2. When the audio mode is not in the default volume control setting, press the
knob, until the display says
knob. This way you can set the volume to your needs.
B. BASS SETTINGS
1. Keep pressing the knob until the screen says
or right to set the value.
C. TREBLE SETTINGS
1. Keep pressing the knob until the screen says
or right to set the value.
D. BALANCE CONTROL FOR LEFT AND RIGHT SPEAKERS
1. Keep pressing the knob until the screen says
or right to set the value.
E. FADER BALANCE CONTROL FOR FRONT AND REAR SPEAKERS
1. Keep pressing the knob until the screen says
or right to set the value.
F. MANUAL AND AUTOMATIC TUNING, FAST FORWARD AND
REWIND
1. When listening to the radio, press the >>| or |<< button , to change the
received radio frequency to a higher/lower one. Holding the buttons mentioned
above will make the device automatically set the frequency to a strong
signal broadcasted by a radio station.
2. When playing music from a USB drive or an SD card, pressing >>| or |<< will
switch the track played to the next or previous one.
3. BAND button
Hold the BAND button for 1 second to make the device scan the radio band. If it
scans the FM band, it will automatically scan through the FM4 band after it
finishes scanning the FM1 band. After the scan is finished, the radio will save any
found radio stations.
. . Then set the volume by turning the
24
. Turn the knob left
. Turn the knob left
. Turn the knob left
. Turn the knob left