Dish Setup - Falcon QuickSAT QS65 Bedienungsanleitung

Dish Setup

1) Loosen the fixing clamp on the tripod stand and push the legs
downwards.
2) Extend the feet of the tripod stand as far as they will go for
maximum stability
3) Ideally the tripod should be placed on reasonably level ground so
that the tripod is vertical.
4) Place the compass on the Sat Mat (Item D) and rotate the mat until the red line on the compass lines
up with the red line on the mat (FIG 1).
The blue arrow on the mat is now pointing in the direction of the satellite.
5) Place the tripod over the mat so that one of the tripod legs is in the direction of the blue arrow on the
mat (FIG 2).
Use the ground anchor pegs to secure the tripod so that it isn't accidentally moved or blown over by the
wind.
Satellite Mat (FIG 1) (FIG 2)
6) Fit the dish to the tripod and secure using the large thumbwheel on the tripod. Do not overtighten
the thumbwheel at this point as rotation will be required for the final step in tuning
7) Check that the connectors on the LNB are in a roughly 25 past the clock position (FIG 3). The LNB can
be turned in the mounting to adjust the position.
8) Once the dish is secured on the tripod it should look like the image (FIG 4)
(FIG 3) (FIG 4)
!
Do not connect any leads until your satellite dish is firmly on the tripod
6