Coccolle Freya Bedienungsanleitung Seite 8

EN
7. To avoid serious injury from falling or sliding out, always use seat belt when
using swing.
Battery use and assembly
Loosen the screw in the battery compartment door with a screwdriver (not
included) and remove the battery compartment door.
Insert four AA (LR6) alkaline batteries into the battery compartment.
Replace the battery compartment door and tighten the screws.
Note: Low battery power may cause the product movement to slow down, the
sound and lights to become faint or the product to turn off altogether. If this
should happen, use the AC adaptor as a power source or replace the batteries.
Replace the batteries with four alkaline AA (LR6) batteries.
If this product begins to operate wrong, you may need to reset the electronics.
Turn the power off and then back on.
Swing control plate instructions
1. Power on/off
2. 12 songs
3. 5 speeds
4. 3 timers
5. Power light
6. Volume –
7. 5 nature sounds
8. Speed lights
9. Motion button
10. Motion control light
11. Timer lights
12. Volume +
Power on/off: Press button, the swing connects with power, and power light
turns red.
Nature sound button :5 natural songs, press the button to start from one song,
press again to move to next one.
Speed button: 5 speeds, each speed has a speed light. Press the button to start
from 1st speed, press again for 2nd speed, press for a longer time to turn off the
speed.
Timer button: 3 timers, 15 mins,30 mins, and 60mins. Press button to move to
the next timer. each timer has a timer light too.
Song button: 12 songs totally, press button to start from one melody, press again
to move on to next one.
Volume +/-, press these buttons to adjust the volume of songs.
Motion button: Press this button, when the baby wakes up and rolls on the
swing, the motion detector starts to swing and stop automatically after 10
minutes.
Motion button lights: Press the motion button and the motion indicator lights up.
When the baby wakes up and flips in the swing, the swing function starts
automatically.
The system will automatically shut down and stop after working for 2 hours.
When needed again, please open power switch and restart the product.