Setting Up The Battery Charger (Battery And Charger Not Included); Charging The Battery - Batavia BT-CWL001 Bedienungsanleitung

English
Removing the Battery
To remove the battery from the lamp, press the battery release
button (6), then slide the battery (7) off the hand grip.
WARNING: Do not try to remove the battery without pressing
the battery release button. The lamp or battery could be
damaged.
Fitting a battery
To fit a charged battery, slide it on to the hand grip of the lamp
until it clicks and locks into position.
Note: Make sure the battery and lamp are lined up correctly. If
the battery does not slide into the lamp easily, don't force it.
Instead, slide the battery out of the lamp again, check the top of
battery and the lamp battery slot are clean and undamaged and
that the contacts are not bent.
SETTING UP THE BATTERY CHARGER (BATTERY AND
CHARGER NOT INCLUDED)
1. If fitted, remove any battery from the battery charger.
2. Insert the battery charger mains plug into a suitable mains
socket.
Note: The green LED on the battery charger will blink to indicate
that the battery charger is ready to charge the battery.
WARNING: Only use this charger to charge compatible batter-
ies that are specifically designed for this impact driver.
WARNING: The charger is designed for indoor use only, and
must not be used in damp or wet conditions.

CHARGING THE BATTERY

WARNING: Failure to follow the correct procedure when charg-
ing batteries will result in permanent damage.
Note: Normal charging time is 1 hour for a recently discharged
battery. However, if the battery (7) has been left in a discharged
state for some time, it may take up to 1.5 hours to charge.
28