Hama P2223772 Bedienungsanleitung Seite 9

5. Connection
Warning
• Only operate the product from an approved socket that is
connected to the public power supply. The socket must be
installed close to the product and must be easily accessible.
• Disconnect the product from the power supply using the On/
Off switch – if this is not available, unplug the power cord
from the socket.
• If using a multi-socket power strip, make sure that the total
power consumption of all connected devices does not exceed
the socket strip's maximum throughput rating.
• If you will not be using the product for a prolonged period,
disconnect it from mains power.
Before devices are connected, these devices must all be switched
on. The surge arrester must only be connected between the
consumer and a protective contact socket. In the ready-to-use state,
the control light for surge protection lights up.
Warning
If the control light on the surge arrester does not light up after
switch-on, the surge arrester is faulty. It must not be used and
must be replaced by a new surge arrester.
6. Care and maintenance
Note
Disconnect the device from the mains before cleaning and
during prolonged periods of non-use.
• Only clean this product using a lint-free, slightly damp cloth and
do not use any harsh cleaners.
• Ensure that no water is able to enter the product.
7. Warranty disclaimer
Hama GmbH & Co KG assumes no liability and provides no
warranty for damage resulting from improper installation/mounting,
improper use of the product or from failure to observe the operating
instructions and/or safety notes.
8. Zloty 500,000 insurance cover
Insurance cover of up to Zloty 500,000 for personal and property
damage as part of our product liability insurance. Essential for this
is the proper use of the products (note the safety instructions) and
evidence that the damage can be attributed to failure to provide the
described safety function. (note the technical data on the type plate
and in these operating instructions)
9. Technical data
Surge arrester
Total
leakage current
Mains connection
Cable cross section
Connected load
Up: L-N=1,5kV; L/N-PE=2,0kV;
Uc: 255V~ 50Hz
Uoc: L-N=6,0kV; L/N-PE=6,0kV;
Type III / T3
18.000 A (3 x 6000 A)
250 V ~ / 16 A
1,5 mm
2
max. 3680 W
9