Cleaning And Care - AEG K5-1-6ST Gebrauchsanweisung

13
The automatic switch off function. When the water has boiled or the kettle is moved from the base, it will switch off automati-
cally. If you wish to stop it in the middle of the heating/keeping warm process, simply press the START or KEEP WARM/
TURBO button again. The white LED light on the START or KEEP WARM/TURBO button indicates it's in working progress.
14
When the kettle is lifted up off and put back on the base, the display will show the real time water temperature and
turns off/black after 5 minutes.

CLEANING AND CARE

15
Before cleaning, always unplug the appliance. Never rinse or immerse the kettle or base unit in water. Just wipe with a
damp cloth, using no abrasive detergents. Occasionally rinse out the kettle with clean water.
16
To clean the mesh filter, grab the strainer insert and lift out. Cleaning the heating plate – superficial spots of rust may ap-
pear on the base unit. Remove with a stainless steel cleaning agent.
17
Decalcifying is recommended regularly, depending on water hardness. Fill the kettle with water and decalcifier according to
decalcifier product instructions. Do not boil the solution as it may foam over. Afterwards, rinse kettle thoroughly with fresh
water.
Enjoy your new AEG product!
TROUBLESHOOTING
PROBLEM
The appliance switches off before
boiling.
The appliance does not switch off.
The appliance cannot be switched on.
The display shows "E3" error code.
Kettle alarm, "START" button light
flashing.
Water temperature is lower than the
setting.
DISPOSAL
Recycle the materials with the symbol
environment and human health.
Do not dispose appliances marked with the symbol
recycling facility or contact your municipal office.
AEG reserves the right to change products, information and specifications without notice.
www.aeg.com
K5-1-6ST_WaterKettle_AEG_202206_all lang rev 2.indd 15 K5-1-6ST_WaterKettle_AEG_202206_all lang rev 2.indd 15
POSSIBLE CAUSE
Too much lime scale at the base of the
kettle.
After operating with little or no water,
the appliance has not cooled down
suffiently.
The thermostat is overheated.
The NTC is short-circuited or
disconnected.
Temperature sensor is covered with dirt
after the kettle being misused warming
other food / beverage than water.
Under TURBO program, water volume
is more than 200ml.
. Put the packaging in applicable containers to recycle it. Help protect the
with the household waste. Return the product to your local
SOLUTION
Run the decalcifying
procedure.
Close lid until it locks
Insert the strainer correctly.
Allow to cool a short time and
try again.
Turn off the machine to cool
down or add water again.
Return the machine to service
center.
Clean Temperature sensor, a
pin shaped part, located in the
bottom of inner kettle tank.
Under TURBO program, water
volume less than 200ml.
15
2022-06-09 16:31:34 2022-06-09 16:31:34
BG
NL
EN
FR
DE
GR
PT
ES
AR