General Settings - Peaq PMO S271-IQC Bedienungsanleitung

• If you didn't press any key within 4 hours, the
Monitor will power off automatically. You can
reset the power off time individually from OFF / 0
to 24 under the menu setting Reset.
• Display time: A count-down time of 60 seconds
will be started before turn off. On the display it
will shows: XX (60-0) second to power off, please
push any key to cancel.

General settings

MENU SETTINGS
With the device switched on, press the multifunction
switch to the left. The main menu opens. Press
the multifunction switch up or down to select the
desired submenu. To confirm your selection, press
the multifunction switch again to the left. You can
change the settings by pressing the multifunction
switch up or down. Confirm the setting by pressing
the multifunction switch again to the left.
By pressing the multifunction switch to the right,
you return to the corresponding upper menu.
To close the main menu, press the multifunction
switch to the right until it closes.
The following main menu options are available:
• Luminance
> Brightness
> Contrast
> Eco Mode
> DCR
> Overdrive
• Image Setup
> Image Ratio
• Color Setup
> Color Temp.
> Red
> Green
> Blue
• OSD Setup
> Language
> H. Position
> V. Position
> Timeout
> Transparence
IM_PMO-S271-IQC_210804_V03_HR.indb 13 IM_PMO-S271-IQC_210804_V03_HR.indb 13
• Reset
> Reset
> Off Timer
• Extra
> Input Select
> Volume
> AMD FreeSync
Set menu language
The menu may be preset to English.
For easy use of the self-explanatory menu, it is
advantageous to set it to the respective native
language. Proceed as follows:
1. With the monitor turned on, press the multi-
selector switch to the left.
2. Select the OSD Setup item by pressing the
multi-selector up / down. Confirm the selection
by pressing the multifunction switch to the left.
3. The first point is Language. Press the
multifunction switch to the left to enter the
language selection menu.
4. Select the desired language by pressing the
multi-function switch up / down. Confirm the
selection by pressing the multifunction switch
to the left.
5. The desired language is now set. To exit the
menu, press the multifunction switch several
times to the right.
Reset settings to factory settings
1. With the monitor turned on, press the
multifunction switch to the left.
2. Select the Reset menu item by pressing the
multifunction switch up / down. Confirm the
selection by pressing the multifunction switch
to the left.
3. If necessary, select Reset by pressing the
multi-function switch up / down. Press the
multifunction switch to the left to confirm the
reset. All previously made individual settings
have now been reset and the menu is closed.
ENGLISH
13
5/8/2021 09:56 5/8/2021 09:56