Preparing For Use - Farfalla TRAVEL MOUSE Anleitung

You are advised to change frequently the water in the tank and clean the diffuser once or twice a week, par2cularly if you
want to change the fragrance to be diffused.
1. Turn the diffuser off and unplug it.
2. Remove the covers and pour the water into the tank. Empty the water in the opposite way to the air outlet, do not
empty the water in the air outlet, this would damage the diffuser.
3. Clean the inside of the diffuser with a soD damp cloth and a li9le water. If needed, use the cleaning fluid for essen2al oil
diffuser. Do not use corrosive detergents. Carefully rub the ceramic disc with a co9on bud being careful about not to
scratch it.
1. Place the diffuser on a flat and stable surface and away from the edge.
2. Remove the outer cover and the inner cover from the diffuser.
3. Pour mineral water (bo9led or tap water) into the water tank up to the maximum level indicated (50ml).
4. Then add a few drops of essen2al oils (1-3 drops) to the water tank.
5. Replace the inner cover then the outside cover on the diffuser.
6. Insert the USB cable's connector into the DC jack input on the base of the diffuser. Plug the USB connector into a USB
port or into the adaptor then into the outlet.
This diffuser has an ON / OFF bu9on located at the base of the diffuser.
1. Press once to start the diffusion and the lighAng ambiance.
MAINTENANCE

PREPARING FOR USE

A detailed diagram is available on the last page.
WORKING