Step 10: Pump Top Orientation (Amd); Optional Step! Applying The Thermal Compound; General Safety Warnings - EK -Nucleus AIO CR360 Dark Installationshandbuch

Female Connector
Male Connector
Female Male
Connector Connector
STEP B:
Connect the female connector from the
extension cable to the male connector from
the fi rst fan in line.
Be careful to turn the micro-fi t connector
correctly.
STEP C:
In the case of the EK-Nucleus AIO CR240
or EK-Nucleus AIO CR360 version, connect
the second and third fan in series with the
"daisy-chain".
Be careful to turn the connector correctly.
1 2 3
Non-abrasive
Cloth
IHS

7. GENERAL SAFETY WARNINGS

First aid measures in case of:
Skin exposure to coolant: Remove contaminated clothing and rinse thoroughly with plenty of
running water or normal saline rinse. If symptoms develop and persist, seek professional medical
attention.
Eye exposure to coolant: Immediately open upper and lower eyelids, fl ush out with running water
or normal saline rinse. If irritation persists, seek professional medical attention.
Inhalation of coolant: Remove yourself from site to fresh air. If symptoms develop and persist,
seek professional medical attention.
Ingestion of coolant: Drink plenty of warm water and do not induce vomiting. In case of doubt or
if felling unwell, seek professional medical attention.
Skin exposure to thermal paste: Wash thoroughly with soap and water for a minimum of 15
minutes. Contaminated clothing should be removed immediately. If irritation persists, obtain
medical attention.
- 12 -
STEP 10: PUMP TOP ORIENTATION
(AMD)
4
Lift the top, rotate it until the EK logo is oriented
correctly, and put it back down. The magnets
will hold the top in place.
Congratulations! You have
installed your EK-Nucleus AIO.
OPTIONAL STEP! APPLYING THE
THERMAL COMPOUND
This step is relevant only in the case of a
second installation of AIO or if you have
damaged the pre-applied paste on the
backside of the pump unit. For the fi rst
installation, you don't need to apply the
additional thermal compound to the CPU's
contact surface.
Wipe the CPU's contact surface (using a non–
abrasive cloth or Q-tip, as shown on sample
photo). On a clean IHS, apply a line of thermal
compound and spread it over the whole CPU
heat spreader (IHS) with a credit card or
equivalent.
successfully