Making Hot Water - Hisense HESCM15DBK Gebrauchsanleitung

2. Set steel mesh into metal funnel, make sure the tube on the funnel aligns with groove in the
appliance, then insert the funnel into the appliance from the "INSERT" position, and fix them into
coffee maker firmly by turning it anticlockwise until it is at the "LOCK" position.
3. Place a cup on removable cup shelf.
4. After preheating is completed, press 1-cup or 2-cup coffee button, the product will start brewing,
working time for 1-cup coffee is 15 seconds and 25 seconds for 2-cup coffee . if you want to get the
amount of coffee you like, press manual coffee button once, when your desired quantity of coffee is
reached, press this button again to stop, for manual coffee button, working time is Max 90s, unit will
automatically stop working if no any operation within 90s.
5. At the time corresponding coffee button indicator is to be illuminated, if it is extinguished, wait for a
moment, once it is illuminated again, press corresponding coffee button, wait for a moment, there will
be coffee flowing out.
6. Press Coffee button when desired coffee is obtained or the colour of coffee changes weak obviously,
coffee maker stops working, if coffee button indicator is extinguished, wait for a moment, coffee
button indicator will be illuminated again, you can continue to make coffee.
7. Press and hold 1-cup button for 3 seconds, 1-cup button flashes, entering setting mode, press 1-cup
button again to start dispensing coffee, when the specified time is reached, press 1 cup button to
complete setting which can be memorized by the unit. Working duration for 1-cup coffee can be set
up to 45s, if working duration for 1-cup coffee is set, working duration for 2-cup coffee will be
automatically updated to 2 times of that for 1-cup coffee ; Working duration for 2-cup coffee can be
set up to 90s, if working duration for 2cup coffee is set, working duration for 1-cup coffee will be
automatically updated to half of that for 2-cup coffee
WARNING: Do not leave the coffee maker unattended during making coffee, as you need operate
manually sometimes!
8. After finish making coffee, take metal funnel out by turning it clockwise, then pour coffee residue out
with steel mesh pressed by press bar.
9. Let them cool down completely, then rinse under running water.

Making hot water

When the product is preheated, turn the steam knob to release hot water and press the manual coffee
button to start the preparing hot water. Press the manual coffee button again and close the steam knob to
finish preparing the hot water.
Make cappuccino/frothed milk
You get a cup of cappuccino when you top up a cup of espresso with frothed milk.
Method:
1. Prepare espresso first with container big enough according to the part "MAKE ESPRESSO", make
sure that steam control knob is at the OFF position.
2. Press Steam button, Coffee button indicator will be extinguished, wait until Steam button indicator is
illuminated.
Note: During operation, Steam button indicator will cycle on and off to maintain desired temperature.
3. Fill a jug with about 100 ml of milk for each cappuccino to be prepared, you are recommended to use
whole milk at refrigerator temperature (not hot!).
Note: In choosing the size of jug, it is recommended the diameter is not less than 70±5mm, and bear
in mind that the milk increases in volume by 2 times, make sure the height of jug is enough.
4. Turn steam control knob slowly anti-clockwise, steam will come out from frothing nozzle
Note: Never turn steam control button rapidly, as the steam will accumulate rapidly within short time
which may increase a potential risk of explosion.
5. Insert frothing nozzle into the milk about two centimetre, froth milk in the way of moving vessel round
up and down.
6. When the required result is reached, turn steam control knob to OFF position.
Note: Clean steam outlet with wet sponge immediately after steam stops producing, but care not to
hurt!
6